29
TTS
NOTE
By keeping to the same angular position, any symmetry deviation will
not affect the reproducibility of the measurement results.
4.2 Fitting the lever
Depending on the nominal (rated) torque, there are one, two or three parts to
the lever. To make assembly easier, apply a little oil to the mating surfaces of
the individual components.
4.2.1 One-piece lever (nominal (rated) torque 100 N@m)
• Press down the spring bolts of the lever.
• Push the lever as far as it will go into the receiving hole in the measuring
head.
• Turn the lever from side to side until you hear the spring bolts engage.
Spring bolt
Measuring head
Fig. 4.10: One-piece lever
A1571-1.2 de/en
HBM