7B70 (SN B205000 and Up)
TABLE OF CONTENTS
SECTION 4
MAINTENANCE (cont)
(cont)
SECTION 5
l ntroduction
Test Equipment Required
Short Form Procedure
Performance Check/Calibration Procedure
General
Preliminary Control Settings
Check/Adjust Steps (refer to Short-Form Procedure
for index to steps)
SECTION 6
ELECTRICAL PARTS LIST
Abbreviations and Sym~bols
Parts Ordering Informatioil
Index of Electrical Parts List
SECTION 7
DIAGRAMS
SECTION 8
MECHANICAL PARTS LIST
CHANGE INFORMATION
Abbreviations and symbols used in this manual are based on or
taken directly from IEEE Standard 260 "Standard Symbols for
Units", NllL STD-12B and other standards of the electronics
industry. Change information, if any, is located a t the rear of this
manual.
Page
4- 2
4- 2
4-3
4-3
4-5
4-5
4-6
4-6
4-8
Scans by ArtekMedia O 2006
Need help?
Do you have a question about the 7B70 Time Base and is the answer not in the manual?