Page 2
Introduction/How Does Digital Satellite TV Work? About this manual —We hope this manual will provide clear instructions to install and operate MV-3500. Two symbols have been used — Indicates suggestions to make Indicates caution should be taken! processes easier for you.
Page 3
4. Operation (Vehicle MUST be stationary!!) 4. Once the unit has acquired GPS, the dish will 1. Turn on receiver and television set. The MV-3500 begin its search. must be connected to a receiver that is plugged into 120 VAC.
Page 4
To toggle between satellites when subscribing to multi-satellite programming— The MV-3500 will toggle between the primary and If this is the first time the receiver has been seconday satellites for either DISH Network or used, you may need to download receiver DIRECTV but not between DISH Network and software;...
Parts Included • Tools Needed • How to Unpack PARTS INCLUDED: 1 Radome 1 Cable entry plate 1 large yellow spade connector 3 base mounting feet 2 small red spade connectors 1 Power switch 2 Wall plates (white & brown) All required screws and washers 1 base with electronics, dish, dual LNBF 1 Surface mount box...
Installation tion below. Installing unit on roof of vehicle — (#1 represents Switch DOWN; #0 repre- Install in DRY conditions only! sents Switch UP) IMPORTANT! Do not install this system in the rain, or under any wet conditions. Mois- ture may affect electronics and void your Sat.
Page 8
Installation GPS installation — ROOF INSTALLATION, continued Place the unit on the roof in its permanent loca- The GPS antenna is pre-wired and has a 3 foot tion and mark around each base foot, Figure 4. cable running through one of the connectors. (Make sure the rear adjustable base foot is par- When deciding where to place GPS antenna, DO allel to the center line of the coach.)
(not provided) between the unit and your cable-entry plate. Clamping the cable every 12”- 16” should eliminate any unnecessary cable 3. Connect red power wire from MV-3500 using movement, Figure 7, see above. red spade connector to center spade on switch.
Page 10
— Connecting one receiver 1. Be sure vehicle is in a location free of all obstruc- 1. Connect the coax cable from the MV-3500 to the tions and with a clear view of the satellite. “SATELLITE IN” on the receiver.
Troubleshooting SOLUTION PROBLEM The MV-3500 does not attempt to find a satellite 1. Check your Power switch to verify that it is in the ON position. or it never moves. 2. Make sure that the receiver is plugged in and the satellite in jack is connected to MV-3500.
Company, 3000 Kirkwood Street, Burlington, Iowa 52601-2000, telephone 319-754-0600). Winegard Company (at its option) will either repair or replace the defective product at no charge to you. This warranty covers parts, but does not cover any costs incurred in removal, shipping or reinstallation of the product. This limited...
Need help?
Do you have a question about the Movin’ View MV-3500 and is the answer not in the manual?
Questions and answers