Table of Contents
Advertisement
To replace the glass panels,
do the same steps in
reverse. Before you lower
the trim, attach the A trim
part to the door. Refer to the
image.
11.7 Replacing the lamp
Put a cloth on the bottom of the interior
of the appliance. It prevents damage to
the lamp glass cover and the cavity.
WARNING!
Danger of electrocution!
Disconnect the fuse before
you replace the lamp.
The lamp and the lamp glass
cover can be hot.
12. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
12.1 What to do if...
Problem
You cannot activate the ap-
pliance.
You cannot activate the ap-
pliance.
You cannot activate or oper-
ate the hob.
You cannot activate or oper-
ate the hob.
You cannot activate or oper-
ate the hob.
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactivated.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box
or deactivate the circuit breaker.
The back lamp
1. Turn the lamp glass cover
counterclockwise to remove it.
2. Clean the glass cover.
3. Replace the oven lamp with a
suitable 300 °C heat-resistant oven
lamp.
Use the same oven lamp type.
4. Install the glass cover.
Possible cause
The appliance is not connec-
ted to an electrical supply or
it is connected incorrectly.
The fuse is released.
You touched 2 or more sen-
sor fields at the same time.
STOP+GO function oper-
ates.
There is water or fat stains
on the control panel.
You put something on one
or more sensor fields.
The lamp glass cover is at
the back of the cavity.
Remedy
Check if the appliance is cor-
rectly connected to the elec-
trical supply.
Make sure that the fuse is
the cause of the malfunction.
If the fuse releases again
and again, contact a quali-
fied electrician.
Touch only one sensor field.
Refer to "Hob - Daily use"
chapter.
Clean the control panel.
Remove the object from the
sensor fields.
ENGLISH
31
Advertisement
Table of Contents
