Advertisement
ECU Installation
To install your new Platinum Pro Plug-in to your Hyundai Genesis, please follow the
procedures below.
You will require the following tools
Socket set with 10mm socket,
•
Haltech Mounting Kit
•
1.
Locate your factory ECU. This will be located in the engine bay, near the firewall
on the drivers side.
2.
With the ignition turned off remove the ECU connector from the ECU by lifting the
connector levers up and pulling the connectors out.
With the connector disconnected, remove the Factory ECU from the engine bay by
loosening the 4 x 10mm bolts securing it to the mounting bracket.
Figure 1 – ECU Location in engine bay
Figure 2 – Factory ECU disconnected and removed
Advertisement
Need help?
Do you have a question about the Platinum Pro Plug-in and is the answer not in the manual?
Questions and answers