Configure Your Xbee Wi-Fi Module With Xctu - Digi XBee Wi-Fi Cloud Kit Getting Started Manual

Do more with your XBee Wi-Fi Cloud Kit
Note Firmware updates are available for download on our Support site:
www.digi.com/support/productdetail?pid=5585&type=firmware

Configure your XBee Wi-Fi module with XCTU

This tutorial assumes you have installed XBee Wi-Fi on the development board and connected to the
user's computer via USB, and that you have installed
1. Verify that the two DIP switches labeled as "UART RX" and "UART TX" are switched to the
"On" position on the development board.
2. Open XCTU and click Add a radio module
3. Select the Serial/USB port where the development board is currently connected. In this
example, the development board is connected to COM3.
4. Verify that the baud rate and other communication settings match those on the module.
Note If the default serial configuration has not been changed on the module, the defaults listed
in the discovery tool will work.
5. Click Finish to begin automatic device discovery.
XBee Wi-Fi Cloud Kit Getting Started Guide
Configure your XBee Wi-Fi module
XCTU installed on your system.
.
28