WAREMA WMS Wall-mounted transmitter plus Operating And Installation Instructions page 8

Button/
Cction/result
display
By pressing the UP and DOWN arrow buttons,
you can select the desired receiver/product
type:
Press UP
Flashing increases by one

Press DOWN
Flashing decreases by one

Depending on the frequency with which

the control function LED
corresponding product type is displayed:
1 x GREEN: Awning
2 x GREEN: Roller shutter
3 x GREEN: External venetian blind
4 x GREEN: Light
5 x GREEN: Window
+ To check which product type was set,
+
press .
The flashing of the control function LED

indicates which product type was
selected.
O IUTCCE If the desired receiver is not wav-
ing after the
pressed, a brief press of the
button switches to the next receiver
found during the scan.
Press the STOP button
The appropriate product type is now as-

signed to the receiver.
The transmission LED

seconds.
GRCECEO
O IUTCCE The first receiver that is learned into the WMS
Hand-held transmitter plus/Wall-mounted
transmitter plus defines the type of channel
that is selected.
If an external venetian blind is learned in as
the receiver first, the channel type is defined
as an external venetian blind channel and
only external venetian blinds can be learned
in.
Transmission LED

GRCECEO:
The transmission LED

IRCOGCE:
Briefly press the learn button to leave the
learn mode.
8
We reserve the right to make technical changes
flashes, the
+
button has been
.
lights up for 2
This confirms the allocation.
flashes.
The scan process is now
repeated automatically until
no more new devices are
found.
lights up.
The scan is ended.
CExample 6:
Delete learned-in products from the WMS Wall-
mounted transmitter plus and the network
You can remove the learned-in products completely from
the WMS Wall-mounted transmitter plus and the network.
First, scanning is repeated (see example 5 on page 7)
to identify the learned-in devices.
O IUTCCE Devices that do not need to be deleted must be
de-energised.
As soon as the transmission LED lights up orange, you
can start the deletion process.
Button/
Cction/result
display
+ Select the channel using the
Press the learn button on the WMS Wall-
mounted transmitter plus for approx. 5
seconds.
L LED lights up green; the transmission
+

LED flashes. For several seconds, the
wall-mounted transmitter scans the operat-
ing range for receivers.
By pressing the learn button again, the
process can be aborted.
The L LED goes out.

If, while scanning, the WMS Wall-mounted
transmitter plus finds a target device (receiver,
transmitter, sensor) that has already been
learned in:
The transmission LED

GRCECEO:
Lights up continuously for 2 seconds.
Then scanning continues.
The transmission LED

seconds.
IRCOGCE Scanning stops.
Press the STOP button
+
taneously.
The delete command is sent to all learned-

in receivers.
Those receivers that are still learned-in

wave when they are deleted from the WMS
Hand-held transmitter plus/Wall-mounted
transmitter plus and the network.
The transmission LED
of the deletion process:
Transmission LED

GRCECEO: The devices are deleted.
Transmission LED

RCED:
Not all target devices have been deleted.
Press the STOP button
The deletion command is sent repeatedly

to find receivers that were not within the
radio range during the first deletion com-
mand and to delete them as well.
Briefly press the learn button to leave the
learn mode.
+
button.
lights up.
lights up for 2
and simul-
indicates the result
flashes.
flashes.
.
2018151_d•en•2019-10-01