Step 2:
Copy a channel from a WMS Wall-mounted transmitter
plus to a WMS Hand-held transmitter comfort
Button/
Cction/result
display
+
Select the channel using the
If an unassigned channel is
O
IUTCCE
selected, press the
5 s. As soon as the LED flashes,
all channels can be selected by
pressing the
Press the learn button briefly.
L LED
lights up green.
Wake up the WMS Hand-held transmitter
comfort with any product button.
Select the desired channel on the target
transmitter by pressing and holding the
button of the desired product.
Briefly press the learn button on the TARGET
TRANSMITTER.
L LED
The transmission LED
Wall-mounted transmitter plus flashes.
GRCECEO
GRCECEO
RCED
The L LED
transmitter plus goes out.
2018151_d•en•2019-10-01
+
button.
+
button for
+
button again.
lights up green.
on the WMS
During the transmission of data
from the WMS Wall-mounted
transmitter plus to the target
transmitter; this ends with
Lights up continuously for 2 sec-
onds, transmission successful
Lights up continuously for 2 sec-
onds, error during transmission
on the WMS Wall-mounted
CExample 5
Learn the WMS Wall-mounted transmitter plus
into a new receiver (plug receiver, actuator, etc.)
O
IUTCCE
The system can be comfortably commissioned
using our PC software WMS studio pro, a WMS
Central transmitter or the WMS Hand-held
transmitter comfort.
Devices that do not belong to a network yet,
O
IUTCCE
and are not intended to be learned in, must be
de-energised.
Button/
Cction/result
display
+
Select the channel using the
If an unassigned channel is
O
IUTCCE
selected, press the
5 s. As soon as the LED flashes,
all channels can be selected by
pressing the
Press the learn button on the WMS Wall-
mounted transmitter plus for approx. 5
seconds.
L LED
lights up green; the transmission
+
LED
flashes. For several seconds, the
wall-mounted transmitter scans the operat-
ing range for receivers.
By pressing the learn button again, the
process can be aborted.
The L LED goes out.
If, while scanning, the WMS Wall-mounted
transmitter plus finds a target device (receiver,
transmitter, sensor) that has already been
learned in:
The transmission LED
GRCECEO:
Then scanning continues.
The WMS Wall-mounted transmitter plus does
not find any device during scanning:
The transmission LED
IRCOGCE:
If the WMS Wall-mounted transmitter plus
finds a receiver, transmitter or sensor that has
not yet been learned in, scanning is stopped.
It is indicated as follows:
The transmission LED
RCED:
+
When you press the
can check WHICH target device was just
found.
The product then waves and the control
function LED
GRCECEO: The target device is a receiver
We reserve the right to make technical changes
+
button.
+
button for
+
button again.
lights up.
Lights up continuously for 2
seconds.
lights up.
No receiver found.
lights up.
New receiver
+
button briefly, you
flashes.
for which the product type can
be adjusted.
7
Need help?
Do you have a question about the WMS Wall-mounted transmitter plus and is the answer not in the manual?