Button/
Cction/result
display
Select the channel on the WMS Wall-
+
mounted transmitter plus (2) using the
button.
O
IUTCCE
If an unassigned channel is
selected, press the
5 s. As soon as the LED flashes,
all channels can be selected by
pressing the
Briefly press the learn button on the TAR-
GET TRANSMITTER (WMS Wall-mounted
transmitter plus 2).
L LED
lights up green.
The transmission LED
Wall-mounted transmitter plus (1) flashes.
GRCECEO
During the transmission of data from the
WMS Wall-mounted transmitter plus (1) to
the WMS Wall-mounted transmitter plus
(2); this ends with
GRCECEO
Lights up continuously for 2 seconds,
transmission successful
RCED
Lights up continuously for 2 seconds, error
during transmission
The L LED
transmitter plus (1) and (2) goes out.
6
We reserve the right to make technical changes
+
button for
+
button again.
on the WMS
on the WMS Wall-mounted
CExample 4:
Uhe existing unit with a WMS Wall-mounted
transmitter plus is expanded to include a WMS
+
Hand-held transmitter comfort
Step 1:
Cdd the WMS Hand-held transmitter to the existing net-
work with a WMS Wall-mounted transmitter plus
Button/
Cction/result
display
Wake up the WMS Wall-mounted transmit-
ter plus with the STOP button
Wake up the WMS Hand-held transmitter
comfort with any product button.
Press the learn button on the WMS Wall-
mounted transmitter plus for approx. 5
seconds.
lights up green; the transmission LED
+
(large) WMS Hand-held transmitter scans
the operating range for devices.
The WMS Wall-mounted transmitter plus does
not find any device during scanning:
The transmission LED
IRCOGCE:
If the WMS Wall-mounted transmitter plus
finds a receiver, transmitter or sensor that has
not yet been learned in, scanning is stopped.
It is indicated as follows:
The transmission LED
RCED:
+
When you press the
can check WHICH target device was just
found.
The product then waves and the control
function LED
RCED:
The target device (transmitter or sensor)
can be added to the network.
Press the STOP button
The found target device (transmitter or
sensor) is added to the network.
The target device waves in confirmation.
Briefly press the learn button
the learn mode.
You can now add additional scanned products in the
same manner.
Briefly press the learn button to leave the
learn mode.
O
IUTCCE
If the large WMS Hand-held transmitter comfort
is still in its factory state (no products have
been learned in yet), the
after the transmitter wakes up.
flashes. For several seconds, the
lights up.
No receiver found.
lights up.
New device
+
button briefly, you
flashes.
.
lights up in red
2018151_d•en•2019-10-01
.
to leave
Need help?
Do you have a question about the WMS Wall-mounted transmitter plus and is the answer not in the manual?