Table of Contents
Advertisement
Acclarix LX4 Diagnostic Ultrasound System User Manual
10 In Between Exams
10.1 Unpacking
Visually examine the package prior to unpacking. If any signs of mishandling or damage are
detected, contact the carrier to claim for damage. After unpacking the device, you should follow
the packing list to check the product carefully and to make sure that no damage has occurred
during transportation. For installation, please contact your local distributor or the EDAN service
department at: support@edan.com.cn.
1. Do not use the device if it is found to be damaged or defective.
2. Do not drop or collide with the transducer. Otherwise you shall give up using it.
3. Make sure the AC power supply complies with the following specifications:
100V-240V~, 50Hz/60Hz, 2.5A-1.2A.
10.2 Transport
Power off the system and secure all accessories before moving it to another location.
1
Switch off the ultrasound system. Unplug the AC plug from the power source and
secure the power cable.
2
Remove the transducer and place them in a safe place.
3
Disconnect and secure the connecting cable.
4
Connect optional system accessories.
5
Secure the system and complete the system setup, and then perform all the daily
checking before using it.
To prepare the system for shipment over long distances or rough terrain, repack the system in the
factory packing
To prepare the system for transport over distances: load the system into a vehicle using a lift gate.
To prevent lateral movement of the system, secure the system with cargo straps. To prevent
sudden jarring of the system during transport, provide anti-shock cushions beneath the system.
It is suitable for transportation by air, railway, highway and ship. Protect the system from
inversion, collision, and splashing with rain and snow.
10.3 Storage
Do not place the device near the ground, walls or the roof.
Keep good indoor ventilation. Avoid strong and direct sunlight, and erosive gas.
WARNING
CAUTION
- 135 -
In Between Exams
Advertisement
Table of Contents
