Fujitsu Super High Power Series Design & Technical Manual page 119

¢ Configuring the remote control (Radio)
During commissioning, after an installation period of approximate 3 minutes, the user's language
must be set:
OK
• Press the key
• Choose menu "Operator section".
• Choose "Language".
• Select the language menu (English, Français, Nederlands, Español, etc.)
In the case of 2 heat circuits;
– Choose the allocation of the remote control unit (room appliance 1 or 2...) line 40.
– According to the allocation selected check and, if necessary, modify the settings for lines 42, 44,
48.
Line Access
I
40
This line regulates the use of the room control unit. Depending on how it is used, other settings
will be necessary (Lines 42, 44, 48).
42 I
I
44
This function enables you to choose whether you wish the room thermostat (as an option) to act
both zones or just a single zone.
48 I
NOTE: These parameter lines are accessible from the remote control unit.
4-3. Connections to the heat pump regulator (Accessories and Options)
.
Function
Use as...
Appliance allocation 1
Operation HC2 (command HC2)
Occupancy control switch function
Setting range or display
Room appliance 1, 2, P
User interface 1, 2, P
Service appliance
Heating circuit 1
Heating circuit 1 and 2
Heating circuit 1 and P
All the heating circuits
Commonly with HC1
Independent
Without
Heating circuit 1
Heating circuit 2
Common
- (03-75) -
Factory
setting
Room
appliance 1
Heating
circuit 1
Commonly
with HC1
4. Electrical connections