Start Safely - Hyundai HSL1500T Wheel Manual

CHECK THE CONDITION OF THE
SAFETY AND WARNING LABELS
1. Keep the safety and warning labels clean and legible.
2. Wash the labels with soap and water. Dry with a soft
cloth.
3. Replace all damaged and lost labels.
4. If a part with a safety or warning label affixed to it
needs replacing, ensure the new part also has the warning
or safety label.
5. When replacing labels, ensure that the surface beneath
is clean, dry and free from oil and grease.
6. Press air bubbles towards the outside edges.
WARNING
WARNING
WARNING
IMPORTANT
1. SAFETY PRECAUTIONS
To avoid personal injury,
lower the lift arms, shut off
the engine, raise the seat bar
and cycle the controls to
ensure they are locked.
Then, unlatch the seat belt
and exit the loader. Do not
enter or exit with the engine
running unless as specified
in this manual or under
specific service and backhoe
operating procedures.
To prevent personal
injury do not operate the
loader without lowering
the safety bar, fastening
the seat belt and keeping
feet on the control pedals
or cab floor.
To prevent personal
injury do not start the
engine unless you are in
the seat with the seat belt
fastened around you.
This engine is equipped
with glow plugs. Do not
use ether or any high
energy fuels to assist
starting.

START SAFELY

1. Sit in the operator's seat and adjust it so you can
operate all of the controls properly.
2. Adjust the seat and fasten the seat belt. Cycle the
controls to make sure they are in the locked or neutral
position. Lower the seat bar.
3. Know the exact starting procedure for your machine.
See Section 3 for the manufacturer's instructions for
starting.
C - 360
7