Table of Contents
Advertisement
3.1
STARTING INSTRUCTIONS
1. Pre-Starting Inspection
Before starting the loader complete the following
inspection:
(1) Check the hydraulic oil level, engine oil level, engine
coolant level and fuel supply.
(2) Check for fuel, oil and hydraulic leaks.
(3) Check lights, battery level and cables.
(4a) Check tire pressure (wheel loaders):
12.00 x 16.5 . . . . 40 - 45 PSI (276 - 310 kPa)
(4b) Check track system (track loaders) for obstructions or
debris. Also check tracks for signs of damage.
(5) Check wheel nut torque 100 - 110 ft. lbs. (136- 149
Nm). Check sprocket hub torque on track loader.
(6) Lubricate all grease fittings.
(7) Check the condition and operation of all safety decals
and equipment – Ensure all shields and safety screens
are in place. If necessary repair or replace before
starting.
For complete daily servicing refer to section 4. 3.
WARNING
2. Starting Procedure – Diesel
1.
Ensure the seat bar is in the UP position, the steering
controls are centered and the foot pedals are locked.
2.
Adjust and fasten the seat belt securely around you.
3.
Place the throttle control in idle position.
4.
Turn the ignition key counter clockwise to activate the
glow plugs. Hold approximately 15 seconds. Both the
alternator and engine oil pressure warning lights
should be on.
5.
Turn the key clockwise to start position to engage the
starter. Do not crank the starter for more than 15
seconds. If the engine fails to start turn the key counter
clockwise and pre-heat again.
6.
When the engine has started the engine oil pressure
and alternator warning lights should go out. If they
don't, shut - off the engine immediately and determine
cause.
24
3. OPERATION
To prevent personal
injury do not operate the
loader without lowering
the safety bar, fastening
the seat belt and keeping
feet on the control pedals
or cab floor.
IMPORTANT
WARNING
7.
Allow the engine to warm up for five minutes before
operating. When ready to operate, lower the seat bar
and advance the throttle to full on position.
3. Shut-Off Procedure
(1) Select level ground whenever possible. If you must
park on a slope or incline, position the machine at
right angles to the slope. Lower the attachment to the
ground, engage the parking brake and block the
wheels.
(2) Lower the lift arms and ground the attachment.
(3) Return auxiliary hydraulics to neutral or OFF position.
(4) Return the throttle control to idle position. If the
engine is hot allow it to idle until normal. At least 2
minutes.
(5) Never enter or exit the loader when the engine is
running.
(6) Raise the seat bar to apply the park brake. Turn the
ignition switch to the OFF position, remove the key,
unfasten the seat belt, and ensure the hydraulic
controls are locked by rocking them.
WARNING
This engine is equipped
with glow plugs. Do not
use ether or any high
energy fuels to assist
starting.
To avoid personal injury
do not start the engine
unless you are in the seat
with the seat belt
fastened around you,
unless as specified in this
manual or under specific
service and backhoe
operating procedures
To avoid personal injury,
lower the lift arms, shut off
the engine, raise the seat bar
and cycle the controls to
ensure they are locked. Then,
unlatch the seat belt and exit
the loader. Do not enter or
exit with the engine running
unless as specified in this
manual or under specific
service and backhoe
operating procedures.
.
Advertisement
Table of Contents
