Hyundai HSL1500T Wheel Manual page 26

3. OPERATION
3. 4 FILLING FROM A PILE
Push down on the toe of the lift arm pedal and lower the lift
arms completely down (Fig. 3.3A). Push the toe of the bucket
pedal and place the cutting edge of the bucket on the ground.
For hand control units, move the L.H. control lever towards
you and lower the lift arms completely down. Move the R.H.
control lever away from you (Fig. 3.3A) and place the cutting
*
edge of the bucket on the ground.
Drive the loader forward slowly. As the bucket begins to fill
push on the heel of the bucket pedal to raise the front of the
bucket (Fig. 3.3B) and push on the heel of the lift arm pedal
LH
to raise the lift arms. When the bucket is full back away from
R H
the pile. For hand control units, move the R.H. control lever
towards you to raise the front of the bucket, and move the
L.H. control lever away from you to raise the lift arms (Fig.
3.3B). When the bucket is full back away from the pile.
C706
Fig. 3.3A
To dump the bucket (Fig. 3.3C) push down on the heel of the
lift arm pedal to raise the lift arms. Push down on the toe of
the bucket pedal small amounts as the lift arms are raising to
stop material from falling off the back of the bucket. When
the bucket is at the correct height for dumping, push on the toe
of the bucket pedal to empty the bucket.
For hand control units, move the L.H. control lever away
from you (Fig. 3.3C) to raise the lift arms. Move the R.H.
control lever away from you in small amounts as the lift arms
*
are raising to stop material from falling from the back of the
bucket. When the bucket is at the correct height for dumping,
move the R.H. lever away from you to empty the bucket.
LH
* Hand controls not available on all machines.
RH
C707
Fig. 3.3B
C709
*
LH
C710
RH
Fig. 3.3C
27