Hyundai HSL1500T Wheel Manual page 27

3. 5 DIGGING WITH A BUCKET
Push on the toe of the lift arm pedal and lower the lift arms
completely down. Push on the toe of the bucket pedal and
place the cutting edge of the bucket on the ground (Fig.
3.4D). Drive the loader forward at a slow rate and continue
to tilt the bucket down until it enters the ground.
Push down on the heel of the bucket pedal (Fig. 3.4E) to
increase traction and keep an even digging depth.
Continue to drive forward until the bucket is full. When
digging in hard ground, it is easier to raise and lower the
bucket cutting edge with the tilt pedal while slowly driving
forward. When the bucket is full, push down on the heel of
the bucket pedal (Fig. 3.4F) to raise the tip of the bucket.
For hand control units, move the L.H. control lever towards
you to lower the lift arms completely down. Move the R.H.
control lever away from you and place the cutting edge of the
bucket on the ground (Fig. 3.4D). Drive the loader forward at
a slow rate and continue to tilt the bucket down until it enters
the ground. Move the R.H. control lever towards you (Fig.
3.4E) to increase traction and keep an even digging depth.
Continue to drive forward until the bucket is full. When the
bucket is full, move the R.H. control lever towards you (Fig.
3.4F) to raise the tip of the bucket.
* Hand controls not available on all machines.
WARNING
WARNING
WARNING
28
3. OPERATION
To prevent personal
injury, ensure that the
bucket with the proper
rated capacity is being
used for the job you are
doing.
To avoid personal injury:
When starting or
operating loader in an
enclosed area make sure
there is enough
ventilation. Exhaust
fumes can kill.
To prevent personal
injury always carry the
load low.
C711
C713
C715
*
LH
C712
RH
Fig. 3.4D
*
LH
C714
RH
Fig. 3.4E
*
LH
RH
C718
Fig. 3. 4F