Advertisement
vacon • 2
1.1.2
Installation
• Remove the cover from the drive. See the Figure 2.
1
• Open only the inlet holes where you need to run the cables. Cables pass
2
• Connect the supply cable to the Mains switch passing through the cable gland
3
• Place the Mains switch with the cables inside the drive and fix it with its
4
• Connect the cables from the Mains switch to the line terminal. The cables have
5
• Fix the cables with cable clamp.
6
1
Figure 2. Cover open.
through this inlet hole.
from the bottom side (use the cable gland for sealing the cable to the drive)
and then through the terminal box as shown in the figure below.
screws.
to be connected to the terminals L1, L2 and L3.
Vacon 20 X - Mains switch installation
Advertisement
