Temperature Input; Display Menu - Omega CN8200 Series User Manual

Input Menu
Temperature Input Type
Display Parameter
Linear Input Type
Display Parameter

Display Menu

Display Parameter
*NOTE: Does not appear for linear inputs.
Selection
Bias -100 to 100
Lower Setpoint Limit Span of Sensor
Upper Setpoint Limit Span of Sensor
Filtering 0.1-10.0 sec.
Selection
Bias -100 to 100
Low Scale -1999 to 9999
High Scale -1999 to 9999
Lower Setpoint Limit Span of Sensor
Upper Setpoint Limit Span of Sensor
Filtering 0.1-10.0 sec.
Selection
Decimal Position 0-3 Linear Inputs
0-1 TC/RTD
Filter 0.1-10.0 sec
Units* Fahrenheit
Celsius
Kelvin
Blanking 0-9999 sec
,
Output Menu
20 21
The first parameter that needs to be set in the Output Menu is the
Output Type . There are three possible Output Type configurations:
PID, On/Off, Alarm, or Off. (If you are not sure which Output Type is
best for your particular application, refer to the Glossary for an
explanation of Output Types.) The remaining menu parameters in the
Output Menu will change, depending on the Output Type selected.
The Control Menu will also change, depending on the Output Type
selected. If you ordered two outputs, you can select two different
Output Types. After setting your Output Type, refer to the corre-
sponding sections below for the remaining Output Menu parameters.
For simplification purposes, the following sections assume the same
Output Type for both outputs. If you selected different Output Types,
refer to both of those sections.
Output Type
Display Parameter Selection
Output 1 Type
Output 2 Type