Initial Setup Sequence - Omega CN8200 Series User Manual

Figure 11. Chart of Series CN8200 Menu System and
Menu System
Overview
(CONTINUED TO FROM PREVIOUS PAGE)
Functional When Option Card Installed*
*See options manual for
parameter selections.
Security Levels
Mode/ Raise/
Enter Key Lower Key
(three seconds)
Security Levels
(Key Lockout) = No Access
(Setpoint) = Setpoint Value or Output
Percentage (Manual Mode)
(Setpoint plus Mode) = Plus
(User) = Plus
(Configuration) = Plus
(Factory) = Plus
14
Initial Setup
Sequence
Many of the menu parameters you will need to set up the
controller for your application are interdependent. We
recommend following the steps below when configuring
If a key press is not
sensed within five
your Series CN8200.
minutes, the Menu
1) Place the unit in Standby Mode as follows. Press the
System is automatically
exited and the Mode/Enter
controller reverts to the
or Lower
Operating Mode/
again and the upper display will alternate between
Process Value display.
and the process value.
These setup instructions
2) Input Type. Press and hold Menu Access
apply to PID-type
seconds to access the menu system. The Input menu
control outputs.
will be displayed. Then press Mode/Enter
until
select Input Type. If Input Type is set to one of the linear
input options, use the Mode/Enter
scaling limits,
Raise
limits.
3) Output Type. Press the Menu Access
. Use the Mode/Enter
Type parameter. Using the Raise
select the correct Output Type for your application. Follow
these steps (using the Mode/Enter and Raise or Lower
keys) to set the Output Action, Cycle Time, and Limit
parameters for PID outputs. Alarm or on/off output
settings and displays will be different. Refer to Output
menu description on page 31.
15
key for three seconds. Press the Raise
key to select Standby. Press the Mode key
key for three
appears. Use Raise or Lower key to
key to scroll to
and , before proceeding. Use the
or Lower key to set low and high scaling
key to display
key to index to the Output
or Lower
key
keys,