Table of Contents
Advertisement
Min Pulse Width
The minimum allowable pulse width when the laser power is controlled by duty
ratio.
When pulse width is less than this value, this value takes effect.
When pulse width is greater than this value, pulse width in duty ratio takes effect.
Reset Laser
Used to reset the laser device to normal status.
It is required after alarms in laser device are removed.
3.9 Check Machine Tool Setting
After the machine tool commissioning, you need to check whether the machine tool
is set correctly by checking the following:
•
Check pulse equivalent and electronic gear ratio
•
Check pulse
•
Check laser technics
3.9.1 Check Pulse Equivalent and Electronic Gear Ratio
This operation is used to check whether the value of electronic gear ratio matches
that of pulse equivalent.
To check pulse equivalent and electronic gear ratio, do the following:
1.
Make a mark on any axis of the machine tool and set this marked point as the
workpiece origin in the software. See
2.
Move this marked axis for a fixed distance in Jog mode or Handwheel mode
and so on.
3.
Measure the actual moving distance with a vernier caliper and compare
whether it is equal to the distance shown in the software.
3.9.2 Check Pulse
This operation is used to check whether the system loses any pulse.
To check pulse, select one of the following methods:
•
Check pulse through two points
Check pulse by directly observing two points on a workpiece.
•
Check pulse through servo drive
Check pulse by observing pulse count in a servo drive.
上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
Set the Workpiece Origin
58 / 144
for details.
Hide quick links:
Advertisement
Table of Contents
