Table of Contents
Advertisement
Disassembly/ Assembly
Note:
Be sure that Brake band is in "Saw chain brake
release" condition before assembling Brake drum
assembly. If not, set the Link late to that position by
gripping it with a water pump pliers.
10
Fit the Brake drum assembly to Bearing housing.
11
Fit the Retaining ring E type 6 and Flat washer 8.
12
Assemble Motor housing to Gear housing.
13
Fit and tighten the four Tappening screws 5x25.
Use a longer reach screwdriver.
14
Assemble the Carbon brushes and Brush holder
caps on the machine.
Note:
Fit the compression spring 6 on the Front hand
guard.
22 –
English
Advertisement
Table of Contents
