18
Mount Sprocket cover.
3.2 Armature, Spiral bevel gear 12 and 37
DISASSEMBLING
Warning!
Unplugg the machine from the power source.
Remove Saw chain and Guide bar from the
machine for safety before repair/ maintenance.
(1) Disassemble Sprocket cover, Front handle and Spike bumper, see Chapter 3.1.
1
Remove Brush holder caps and Carbon brushes
from the machine.
2
Unscrew the four Tappening screws 5x25. Use a
longer reach screwdriver.
3
Separate Motor housing from Gear housing.
4
Pull out the Armature from Motor housing.
5
Remove Spiral bevel gear 12 by unscrewing M8
Hex nut.
6
Remove Ball bearings from Armature with bearing
extractor.
Disassembly/ Assembly
13
English –