Sony Ericsson T630 Working Instructions page 6

# Figure
12
13
14
15
16
3/000 21-1/FEA 209 544/84 B

SonyEricsson Mobile Communications AB
Instruction
Remove the joystick button
with your fingers.
If necessary use a pair of
tweezers. Put the tweezers
under the joystick button and
press gently upwards.
(fig 1.12)
fig 1.12
Release the PCB from the
frame cavity by overturn the
frame.
(fig 1.13)
fig 1.13
Tilt the camera and remove it
from the camera holder by
sliding it gently with your
fingers in the arrow (1)
direction.
Lift the camera board to board
connector (2) gently with a pair
of tweezers.
(fig 1.14)
fig1.14
Remove the system connector
from the board with your
fingers.
(fig 1.15)
fig 1.15
Remove the speaker gasket.
Use a pair of tweezers.
(fig 1.16)
fig 1.16
Working Instructions, SP/Mechanical
Note
The Joystick may be a little
bit tight fitted to the
switch.
Be careful not to damage
the button, gasket and PCB
when using a pair of
tweezers.
Be careful not to damage
the camera holder or
camera flexfilm when
removing the camera.
Be careful not to damage
the components on the
PCB when using the pair
of tweezers.
Removed speaker gasket
can not be reused and must
be scrapped.
Do not touch the contact
pads on the speaker with
your fingers.
6(34)