Sony Ericsson T630 Working Instructions page 12

#
13
14
15
16
3/000 21-1/FEA 209 544/84 B

SonyEricsson Mobile Communications AB
Figure
fig 2.13
fig 2.14
fig 2.15
fig 2.16
Working Instructions, SP/Mechanical
Instruction
Open the dome foil assembly
ZIF connector.
Take a dome foil assembly and
mount it in the ZIF connector.
Push it into the ZIF connector
with the flex film assembly
tool. It is in the correct
position when the edge is tight
to the connector. Close the
connector with a pair of
tweezers.
(fig 2.13)
Open the display ZIF
connector.
Mount the flex film into the
ZIF connector. Use the flex
film assembly tool. Close the
connector with a pair of
tweezers.
(fig 2.14)
Assemble a new ZIF tape over
the two ZIF connectors by
hand or with a pair of
tweezers.
(fig 2.15)
Gently press the display edges
until the two latches at the
arrows locks the display
assembly in the proper
position with a "click" sound.
(fig 2.16)
Note
Be careful not to damage
the flex film with the flex
film assembly tool.
Make sure the ZIF
connector is properly
closed.
When the connector is
closed a gap between the
flex film edge and the
connector is visible.
Make sure the flex film is
in the proper position
before closing the ZIF
connector.
Be careful not to damage
the flex film with the tool.
Make sure that the ZIF
connector is properly
closed.
12(34)