Sony Ericsson T630 Working Instructions page 10

#
3
4
5
6
7
8
3/000 21-1/FEA 209 544/84 B

SonyEricsson Mobile Communications AB
Figure
fig 2.3
fig 2.4
fig 2.5
fig 2.6
fig 2.7
fig 2.8
Working Instructions, SP/Mechanical
Instruction
Mount the internet access key
with the narrow side down.
Use a pair of tweezers. The
rubber mat extended must be
tight attached to the cavity
walls.
(fig 2.3)
Mount the volume/camera key
with a pair of tweezers.
The rubber mat extended must
be fitted behind the support
pegs at the arrows.
(fig 2.4)
Put the microphone in its place
with a pair of tweezers. The
microphone does not have to
be mounted in any special
direction. Assure that the
elastomer is pointing upwards.
(fig 2.5)
Pick up the speaker with the
flex film assembly tool and
mount the speaker in the frame
cavity.
(fig 2.6)
Mount the speaker gasket over
the speaker. The gasket shall
not cover the contact pads or
speaker cavity edge at the
arrow.
(fig 2.7)
Mount the system connector
on the PCB with your fingers.
Push it on in the arrow
direction
(fig 2.8)
Note
Be careful not to damage
the rubber with the pair of
tweezers.
Make sure that the
volume/camera key rubber
has contact with the frame
cavity walls.
Be careful not to damage
the rubber with the pair of
tweezers.
Do not touch the elastomer
with your fingers but make
sure the elastomer is
pointing upwards.
The contact pads on the
speaker must be mounted
upwards.
Do not contaminate the
speaker contact pads.
The system connector will
be straight and parallel to
the bottom line of the PCB.
Incorrect mounted the
connector can cause
damage to the small
components close to the
PCB bottom line.
10(34)