Sony Ericsson T630 Working Instructions page 11

#
9
10
11
12
3/000 21-1/FEA 209 544/84 B

SonyEricsson Mobile Communications AB
Figure
fig 2.9
fig 2.10
fig 2.11
fig 2.12
Working Instructions, SP/Mechanical
Instruction
Mount the sound channel
gasket on the PCB with a pair
of tweezers.
Use the IRDA sidewall (1), the
PCB edge (2) and the PCB cut
(3) to place it in the correct
position.
(fig 2.9)
Mount the camera holder over
the shielding can, with your
fingers. Snap fit the holder
centred over the shielding can
and make sure that the camera
stop pin (arrow) is correctly
oriented.
(fig 2.10)
Pick up the camera with your
fingers. The flex film on the
camera must be folded under
the camera.
Push the camera into the
camera holder (1) and use the
camera holder stop pins (2) for
the correct position.
Snap fit the camera flex film
(3) onto the board to board
connector with your fingers.
(fig 2.11)
Place the PCB in the frame
cavity.
Start by putting the volume
and camera switch side into
frame cavity and then lay the
PCB down.
(fig 2.12)
Note
The camera holder has
normally not been removed
in disassembly.
This is only to be done if
the camera holder has been
removed by accident.
Make sure that the
switches on the PCB are in
contact with the
camera/volume key.
Check also that the switch
for internet is in contact
with the internet key.
11(34)