Table of Contents
Advertisement
1MRS757054 A
1.4.2
1.4.3
REU615
Application Manual
Manual conventions
Conventions used in IED manuals. A particular convention may not be used in this
manual.
•
Abbreviations and acronyms in this manual are spelled out in the glossary. The
glossary also contains definitions of important terms.
•
Push button navigation in the LHMI menu structure is presented by using the
push button icons, for example:
To navigate between the options, use
•
HMI menu paths are presented in bold, for example:
Select Main menu/Settings.
•
LHMI messages are shown in Courier font, for example:
To save the changes in non-volatile memory, select Yes and press
•
Parameter names are shown in italics, for example:
The function can be enabled and disabled with the Operation setting.
•
Parameter values are indicated with quotation marks, for example:
The corresponding parameter values are "On" and "Off".
•
IED input/output messages and monitored data names are shown in Courier
font, for example:
When the function starts, the START output is set to TRUE.
Functions, codes and symbols
Table 1:
REU615 Functions, codes and symbols
Function
Protection
Three-phase non-directional
overcurrent protection, low stage,
instance 1
Three-phase non-directional
overcurrent protection, high stage,
instance 1
Three-phase non-directional
overcurrent protection,
instantaneous stage, instance 1
Residual overvoltage protection,
instance 1
Residual overvoltage protection,
instance 2
Residual overvoltage protection,
instance 3
Three-phase undervoltage
protection, instance 1
Three-phase undervoltage
protection, instance 2
Three-phase undervoltage
protection, instance 3
Table continues on next page
and
.
IEC 61850
IEC 60617
PHLPTOC1
3I> (1)
PHHPTOC1
3I>> (1)
PHIPTOC1
3I>>> (1)
ROVPTOV1
Uo> (1)
ROVPTOV2
Uo> (2)
ROVPTOV3
Uo> (3)
PHPTUV1
3U< (1)
PHPTUV2
3U< (2)
PHPTUV3
3U< (3)
Section 1
Introduction
.
IEC-ANSI
51P-1 (1)
51P-2 (1)
50P/51P (1)
59G (1)
59G (2)
59G (3)
27 (1)
27 (2)
27 (3)
7
Advertisement
Table of Contents
