olympia electronics GR-60 Quick Manual

GR-60
OPERATION VOLTAGE
MAXIMUM POWER CONSUMPTION
BATTERY (Ni-Cd)
BATTERY PROTECTION
INDICATIONS - CONTROLS
CHARGING TIME
DURATION (adjustable)
ILLUMINATION SOURCE
ILLUMINATION
DEGREES OF COVER PROTECTION
PRODUCED IN ACCORDANCE WITH
OPERATION TEMPERATURE RANGE
RELATIVE HUMIDITY
CONSTRUCTION MATERIALS
EXTERNAL DIMENSIONS
TYPICAL WEIGHT
GUARANTEE
GENERAL
The unit consists of two sections, the charging
base and the detachable illumination unit. The
light source of the unit consists of white
colored high illumination LEDs. These LEDs
light from either the mains power supply, when
the luminaire is on its base, or from the built in
rechargeable batteries. The device offers a
dimming capability by using the incorporated
push button. The incorporated photo-sensor
permits the unit to light only in the dark. By
default, this sensor is disabled. To enable the
photo-sensor function see the section "Photo
sensor activation-deactivation".
Mounting-Operation
The unit can either be mounted on a wall or
placed on a table. If the unit is detached from
the charger then it automatically switches to
emergency operation and can by carried using
the convenient carrying handle. Re-insert the
luminaire on its base in order to charge the
batteries (figure 1).
Charging for the fist time
To use the device for the first time, wait for 15
minutes. To use the luminaire in full autonomy,
charge the batteries for at least 24 hours. The
charging indication is showed by the green
indicator inside the diffusor.
Page 1 from 3
Portable rechargeable ΗΟΜΕ LIGHT
TECHNICAL CHARACTERISTICS
EN 60598-1, EN 60598-2-4, ΕΝ 55015, ΕΝ 61547, ΕΝ 61000-3-2, ΕΝ 61000-3-3
Thank you for your trust in our products
Olympia Electronics - European manufacturer
220-240V AC/50-60Hz
3VA
3.6V/1Ah
From overcharge and deep discharge
Battery charging LED, TEST button
24h
4-14 hours
12 white LED's
230V: 40lm / back up: 23-95lm (max.)
IP20
5 to 40 C
Up to 95%
Bayblend FR3010, transparent polycarbonate
225 x 77 x 58 mm
470gr
3 years (1 year for the battery)
Push button operation
To turn ON the luminaire, press the push button
momentarily. To turn OFF the luminaire press
again the push button momentarily. The setting
is automatically stored into memory. A different
operation mode (ON or OFF) can be selected
when the device is charging or when it is
removed from it's base(or during a power
failure) by using
the push button. For example, to make the
device light when it is on its base(charging) and
also light when it is removed from it's base(or
during a power failure), do the following:
1. Place the unit on it's base and make sure it is
charging(the green led is ON)
2. Press the button so that the white LEDs light.
3. Remove the unit from the base.
4. Press the button so that the white LEDs light.
Now the unit will light when charging and also
light when removed from the base.
You can do the same for other types of
operations.
If the phot-sensor is enabled then this operation
(ON-OFF) is functional only at night.
Light level adjustment (Dimmer)
Remove the unit from the base and press the
button so that the white leds are turned OFF.
Press and hold the push button for more than 2
seconds until the white LEDs light. Release the
push button and press again continuously until
the desired light level has been reached.
o
923060000_09_017