olympia electronics GR-1926/30L/24V/ADR Quick Start Manual

Package Contents
1 Luminaire
3 Pictograms (R/L/D)
Mounting accessories
1
1 Manual
General
o
These devices are used in places (ta 50 C) where emergency light is needed (CBS). Each
device must be permanently connected to mains power supply.
ΑΤΤΕΝΤΙΟΝ!!!
1. Operations for installation, maintainance or testing must be done by authorized personnel
only.
2. Always use in any case round mains cable, with a diameter of 5-10mm (H05RN-F type
2x1mm² or any other type, at least equal to it's mechanical and electrical properties).
ATTENTION!! The cable must not be deformed in any way (This requirement is important to
ensure the ΙΡ rating).
3. The device, must be connected only to the GR-8600 panel via its ADR line.
4. First set the address before installation. To address the device see page 4, step 10.
Dimensional drawing:
315 x 120 x 65 mm
65
315
120
315
Installation
Α
Β
Α
To dismantle the luminaire, simply remove the difussor.
ATTENTION! If the 2 plastic latches (A) are clipped, carefully insert a flat-blade screwdriver
to unclip them. Then, gently lift the diffuser (B) upwards to detach it.
1
1
Β
Place a flat blade screwdriver to the recesses (A) and pull up gently the reflector (B) to remove it.
2
65
120
17
10
4
Install the two rubber gaskets to the holes of the base. Make sure that they are not deformed.
210
3
Wall Plug
Install the plastic base (with the included mounting accessories).
WARNING!! To preserve the IP65 rating, fit the screws with the metallic washers and rubber sealing
rings.
4
2
923192609_09_004
Α
Α
Rubber
Sealing Ring
Screw
Washer
Make a hole in the center of the rubber gasket by using a small screwdriver. Pass the
round cable through the rubber gasket. Connect the mains cable according to the
connections diagrams above.
WARNING!! Isolate the mains power supply before making the connections.
Set the address of the luminaire. To address the device see page 4, step 10.
Please see the manual of GR-8600 for maximum number of luminaires than can be
interconnected.
5
6
Refit the reflector (Mind the holes of the indications).
7
8
Refit the diffusor (Mind the holes of the indications).
8
Β
The plastic latches (A) must be secured (click sound).
Fasten the 2 screws (B). (Tightening torque 1.2N*m)
9
3
923192609_09_004
GR-8600 ADR Line
+L
-L
+L
-L
+L
The other luminairs
-L
Install the included tie-wrap to the adhesive tether
loop and fasten securely the power cable in order to
anchor it.
Α
Β
Α
923192609_09_004