Connection of the flue with in the country/region where the fireplace is Operating control installed. Nordpeis AS is not responsible for incorrect Painting the surround installation. 5. Lighting the fire for the first time Important to check 6.
2. Technical information 3. Distance to combustible material Firewall The inserts from Nordpeis all have secondary Ensure that the safety distances are respected combustion and are clean burning. The combustion (FIG 1). takes place in two phases: first the wood burns and then the gases from the fumes are lit by the hot air.
2-3 times that the insert is used. It is advisable to ventilate the room Regulation of leg height (X) for NI-22: From: 240 mm To: 380 mm. well when firing for the first time as the varnish on the product may release some smoke or smell.
Page 5
For detailed description of the warranty glove that is included. conditions see the enclosed warranty card or visit our website www.nordpeis.com Door and glass Should there be any soot on the glass it may be The CE mark is placed on the side of the insert.
Page 6
cartons and similar are not suitable for lighting a fire. exceed the temperatures determined safe. Good air supply is important at ignition. When the flue Burning briquettes/ compact wood is done so at is hot the draught increases and door can be closed. your own risk and only small amounts (max 1/3 of normal load) should be used for each load.
Page 7
Some advice in case of combustion problems Error Explanation Solution The chimney is blocked. Contact a chimney sweeper / dealer for more information or clean The flue is sooty or there is accumulated soot on the the flue, smoke baffle and burn chamber. No draught smoke baffle.
Page 9
Extra radiation shield NI-22 NB! Bei der Montage in Deutschland, Österreich oder der Schweiz muss zusätzliches Strachlungs- Det ekstra varmeskjoldet skal kun brukes når innsatsen har panoramadør blech verwendet werden. This radation shield is only to be used when the insert has a panoramic door NB! Écran de chaleur supplémentaire doit être utilisé...
Page 13
COMMENTS: THE INFORMATION CONTAINED IN THIS MATERIAL SIZE DWG. NO. DRAWING IS THE SOLE PROPERTY OF NI-22 assembly panorame <INSERT COMPANY NAME HERE>. ANY FINISH REPRODUCTION IN PART OR AS A WHOLE NEXT ASSY USED ON WITHOUT THE WRITTEN PERMISSION OF <INSERT COMPANY NAME HERE>...
Need help?
Do you have a question about the NI-22 and is the answer not in the manual?
Questions and answers