Busch-Jaeger 6730 Manual page 65

Disconnecting/erasing
trans i ters m t
Disconnecting/erasing all the transmitters fro
flush-mounting insert
1 Set the selector switch of the LED display (unit
back) to "EA".
2 After the installation on the flush-mounting in
all of the LEDs light up green for 3 seconds. Afte
that, the LEDs flicker red.
3 Press the complete rocker switch of the LED
display (top and bottom) for more than 5
seconds. After 5 seconds, the first LED li
red. All other LEDs are off.
4 Confirm the selection by briefly actuating the
rocker switch. The LED changes from flashing to
continuous light.
5 Press the operating rocker switch (top or bottom)
for more than
bottom are pressed simultaneously, the function
3 seconds. If the top and the
ENG
m the
sert,
ghts up
65
r