Sub-Zero 700 Service Manual page 7

INTEGRA
INTEGRA
Upper Light Diffuser Removal (All Models)
The side frames of the upper light diffuser have four
inverted "T" shaped slots (two each side) which fit over
pegs protruding from the side walls of the upper com-
partment. Retaining clips at the rear slots secure the
diffuser to the rear pegs.
To remove the light diffuser
1. Slide a finger over the top of each retainer clip
flange and rotate the retainer clip down and back.
2. With clips open, lift the diffuser up and slide it
towards the rear of unit until center of the "T" slots
line up with the pegs.
3. Lower diffuser down and pull forward from the unit.
(See Figure 7-11)
Light Bulb Removal (All Models)
To access the upper light bulbs, the light diffuser must
be removed first. With the diffuser removed, screw the
bulb counterclockwise to remove it and clockwise to
install it. (See Figure 7-12)
The light bulbs in the drawer area are not covered by
light diffusers. Screw the bulb counterclockwise to
remove and clockwise to install.
TED
TED
(736 T (736 T all SWS #2970000) all SWS #2970000)
(See Figure 7-10):
(See Figure 7-12)
SERIES
SERIES
"T" Slots
Retaining Clip
Figure 7-10. Upper Light Diffuser Removal
Line-up Slots with Pegs
Figure 7-11. Upper Light Diffuser Removal
counterclockwise to remove
Figure 7-12. Light Bulb Removal
7-7
Component Removal
#7015817 - Revision A - January, 2010