Sub-Zero 700 Service Manual page 21

INTEGRA
INTEGRA
Compressor Removal
The compressors have four rubber compressor grom-
mets inserted into their base. Cylindrical metal spacers
are placed over threaded studs that are pressed into
the unit tray. The compressor grommets fit over the
spacers and a washer sets on top of the grommet and
spacer. A nut is then installed on the threaded stud and
tightened down on the washer and spacer.
NOTE: Before attempting to remove a compressor,
evacuate the refrigerant from the sealed system.
To remove a compressor, the kickplate/grille will need to
be removed first and the unit tray will need to be slid
out. To slide the unit tray out, extract the two screws
that secure tray to the unit, located at the front right and
left corners. Grab the front flange of tray and pull for-
ward.
1. Use a flat-blade screwdriver to remove compressor
electrical cover.
2. Disconnect electrical leads from compressor.
Figure 7-48)
3. Remove compressor by cutting the inlet and outlet
tubing with a tube cutter, approximately one inch
from the compressor ports.
4. Extract nuts and washers from the threaded studs,
then lift compressor off of studs.
NOTE: Sweating the joints apart is not recommended
as this may induce moisture into the sealed system.
NOTE: The high-side filter-drier must be replaced
whenever servicing the sealed system.
NOTE: When installing a compressor, be sure to thor-
oughly clean the tubing before brazing.
TED
TED
(736 T (736 T all SWS #2970000) all SWS #2970000)
(See
(See Figure 7-49)
(See Figure 7-49)
SERIES
SERIES
Pry up with screwdriver
Figure 7-48. Removing Compressor Electrical Cap
Remove nuts and washers
Figure 7-49. Compressor Removal
7-21
Component Removal
Cut here
#7015817 - Revision A - January, 2010