Sub-Zero 700 Service Manual page 4

Hide thumbs Also See for 700:

Component Removal

Drawer Assembly Removal (All Models)

There are inverted channels on both sides of the draw-

er tubs which rest on telescoping drawer slide assem-

blies. A pin at the front of each drawer slide fits into a

hole in the inverted channel of each drawer tub, holding

the drawer assembly in place.

To remove a drawer assembly

1. Pull drawer open. Lift front of drawer up and off of

pins at front end of drawer slides.

2. Pull drawer assembly forward and off of drawer

slides.

3. Push telescoping drawer slide assemblies back in.

Door & Drawer Gasket Removal (All Models)

The door and drawer gaskets are pressed into retaining

channels that are molded into door and drawer liners.

NOTE:

Drawer assemblies must be removed from the

unit in order to remove and/or install their gaskets.

To remove a door or drawer gasket, simply pull the gas-

ket from the retaining channel.

#7015817 - Revision A - January, 2010

INTEGRA

TED

INTEGRA

TED

(See Figure 7-4):

(See Figure 7-5)

(736 T

all SWS #2970000)

Hole in Channel

Figure 7-4. Drawer Assembly Removal

Channel

Figure 7-5. Gasket Removal

7-4

SERIES

Drawer Assembly

Drawer Slide

Door Gasket

Table of Contents