Sealed System Components - Sub-Zero 700 Service Manual
Hide thumbs
Also See for 700:
- Service & parts manual (93 pages) ,
- Use and care manual (28 pages) ,
- Manual (4 pages)
Advertisement
INTEGRA
INTEGRA
SEALED SYSTEM COMPONENTS
Upper Refrigerator Compartment Evaporator
Removal (736TR, 736TCI)
The upper evaporator is attached to the back wall with
screws.
NOTE:
Before attempting to remove the evaporator,
evacuate the refrigerant from the sealed system.
To remove the upper evaporator, first remove the light
diffuser and evaporator cover, then
1. Extract screws securing evaporator to the back
wall.
2. With a tube cutter, cut inlet tube approximately one
inch from the end and cut the outlet tube approxi-
mately two inches from the end.
NOTE:
Sweating the joints apart is not recommended
as this may induce moisture into the sealed system and
could cause a solder restriction in the capillary tube.
NOTE:
When installing a new evaporator, be sure to
thoroughly clean the tubing before brazing. After brazing
and inspecting the joint for leaks, it is recommended to
apply an acrylic-based paint to the joints to protect the
exposed metals from oxidation.
Lower Compartment Evaporator Removal
The lower evaporator is attached to the back wall with
screws.
NOTE:
Before attempting to remove the evaporator,
evacuate the refrigerant from the sealed system.
To remove the lower evaporator, first remove the heat
exchanger cover, evaporator cover and on the 736TCI
the wire cover. In the model 736TCI, the evaporator fan
shroud will also need to be removed, then
7-44):
1. Extract screws securing evaporator to back wall.
2. With a tube cutter, cut the inlet tube approximately
one inch from the end.
3.
With a tube cutter, cut the outlet tube approximate-
ly two inches from the end.
NOTE:
Sweating the joints apart is not recommended
as this may induce moisture into the sealed system and
could cause a solder restriction in the capillary tube.
NOTE:
If reusing the existing defrost heater, defrost ter-
minator and evaporator thermistor, they can be removed
from the evaporator after it is removed from the unit.
TED
TED
(736 T
(736 T
all SWS #2970000)
all SWS #2970000)
(See Figure 7-43):
(See Figure
7-19
SERIES
SERIES
1"
2"
Cut here
Remove Screws
Figure 7-43. Upper Evaporator Removal
Remove Screws
Figure 7-44. Lower Evaporator Removal
#7015817 - Revision A - January, 2010
Component Removal
Cut here
Advertisement
