Sub-Zero 700 Service Manual page 11

INTEGRA
INTEGRA
Drawer Closer Assembly Removal (All Models)
The drawer closer assemblies are located on the right
and left side walls, towards the front of the two drawer
areas. Screws secure the drawer closer to the wall.
To remove a drawer closer assembly, first remove the
appropriate drawer assembly. Then, extract the screws
that secure the drawer closer to the wall.
7-20)
Switch Box Assembly Removal (All Models)
The switch box assemblies are located on the right side
walls. After the switch electrical leads are attached to
the switch, a flange at the back of the assembly fits into
a slot in the side wall. A screw is then used at the front
to hold the assembly to the wall.
To remove a switch box assembly, first remove the
appropriate drawer assembly, then
1. Extract mounting screw from front of assembly.
2. Pull front of assembly away from side wall slightly
while puling flange at rear of assembly from slot in
side wall.
3. Pull assembly further from side wall and turn bot-
tom of assembly toward front of unit, exposing rear
of switch.
4. Disconnect electrical leads from switch and pull
assembly from compartment.
Drawer Slide Assembly Removal (All Models)
The four drawer slide assemblies are attached to the
side walls with Allen-head screws passing through the
drawer slide bracket into blind threaded inserts.
To remove a drawer slide assembly, first remove the
appropriate drawer assembly, then
1. Starting at rear of slide, use a 5/32" Allen-Head
wrench to extract drawer slide mounting screws.
2. Pull the slide assembly away from the wall and for-
ward out of compartment.
NOTE: The pins at front end of the drawer slides are
replaceable. Screw pins counterclockwise to remove
them. (See Figure 7-22)
TED
TED
(736 T (736 T all SWS #2970000) all SWS #2970000)
(See Figure
(See Figure 7-20A):
(See Figure 7-21):
7-11
SERIES
SERIES
Drawer Closer Assy
Figure 7-20. Drawer Closer Assembly Removal
Figure 7-20A. Switch Box Assembly Removal
Figure 7-21. Drawer Slide Assembly Removal
Pin
Figure 7-22. Pin Replacement
#7015817 - Revision A - January, 2010
Component Removal
Switch Box and
Switch
Drawer Slide Assy