Sub-Zero 700 Service Manual page 12

Component Removal
Icemaker Assembly Removal
(736TFI, 736TCI)
The icemaker sits on a support plate with screws pass-
ing up through the plate into the icemaker bottom. P-
clamps fitting around the back rod of the ice level arm
and screws secured the ice level arm to the plate. A
connecting rod is used between the ice level arm and
the icemaker shut-off arm. This whole assembly is
attached to the evaporator cover with three mounting
screws, two at the top and one at the bottom.
To remove the icemaker assembly, first remove the bot-
tom drawer, then (See Figure 7-23):
1. Extract bottom and two top mounting screws.
2. Lower the icemaker assembly down and disconnect
wire harness at back of icemaker.
3. The icemaker can now be removed from the sup-
port plate by sliding the connecting rod off of the
shut-off arm, then extracting the screws from bot-
tom of icemaker.
Heat Exchanger Cover Removal (All Models)
The heat exchanger cover is held in the back left corner
of the lower compartment with screws that go through
the cover and into stand-offs.
To remove the heat exchanger cover, the drawers and
the left side drawer slides will need to be removed first.
Then, extract the mounting screws and pull the cover
from the unit.
Lower Evaporator Cover Assembly Removal
(Models 736TR)
NOTE: The evaporator fan assembly is attached to the
evaporator cover assembly.
Screws hold the evaporator cover in place. The left
side screws are hidden by the the heat-exchanger
cover. The right side screws secure the cover to the
wire cover, and screws at top secure the assembly to
the ceiling of the lower compartment.
To remove evaporator cover, first remove drawers, left
drawer slides, and heat exchanger cover, then
Figure 7-25):
1. Extract left side mounting screws.
2. Extract screws from top and right side of assembly.
NOTE: Bottom screw on right side also secures the
compartment thermistor.
3. Pull right top front of assembly down slightly and
disconnect evaporator fan electrical leads, then pull
assembly out through upper drawer opening.
#7015817 - Revision A - January, 2010
INTEGRA TED
INTEGRA TED
(See Figure 7-24)
(See Figure 7-25)
(See
(736 T (736 T all SWS #2970000) all SWS #2970000)
Mounting Screw
Figure 7-23. Icemaker Assy
Screw
Heat Exchanger Cover
Screw
Figure 7-24. Heat Exchanger Cover Removal
Screws
Screw
Screw
Figure 7-25. Evaporator Cover Removal, 736TR
7-12
SERIES
SERIES
Shut-off Arm
Connecting Rod
Screws
Evaporator Cover Assembly