Operation - Hans Grohe Talis S 32841 Series Manual

Important! The fitting must be installed, flushed
and tested after the valid norms!
Assembly
1 Flush through the supply pipes.
2 Place the mixer including the sealing
washer in position on the sink.
3 Slip the plastic washer, the slide washer,
the metall washer and collar over the hoses
and threaded base and tighten the collar nut
by hand. If there is not enough space,
please use only the slide washer and the
metal washer without the plastic washer.
4 Slip the plastic washer, the slide washer,
the metall washer and collar over the hoses
and threaded base and tighten the collar nut
by hand. If there is not enough space,
please use only the slide washer and the
metal washer without the plastic washer.
5 Connect the supply pipes to the isolation
valves; cold right - hot left.
6 Connect the hose with hose nut, taper
sleeve, disc and washer.
7 Mount the hose weight - be careful by the
max. drawn out, otherwise the hose could
be crack.
After the assembly!
8 Dismount the handspray and the filter.
9 Flush through the hose.
10 Clean the filter.
11 Mount the filter and the handspray
12 Re-connect down, handscrew (1 Nm).
The hot and cold supplies must be of equal
pressures.
4
English

Operation

The mixer is activated by lifting the lever handle.
Turning to the left = warmer water,
turning to the right = cooler water.
The handspray can be drawn approx. 50 cm out
of the arm lining. The flow is changed from jet to
needle spray by applying slight pressure to the
membrane on top of the handspray. After
shutting off the water flow, the mixer returns
automatically to the bath function.
If the waterflow drops, clean the filter located
between hose and handspray.
Technical Data
Operating pressure:
Recommended operating pressure:
MPa
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Aerator flow rate:
Handspray flow rate:
anti-pollution function
Hansgrohe single lever mixers can be used
together with hydraulically and thermically
controlled continuous flow heaters if the flow
pressure is at least 0,15 MPa.
To adjust the hot water limiter on single lever
mixers, please see page 7.
No adjustment is necessary when using a
continuous flow water heater.
max. 1 MPa
0,1 – 0,5
1,6 MPa
max. 80° C
65° C
10 l/min 0,3 MPa
8 l/min 0,3 MPa