FLIR FC Series Installation Manual page 27

Basic Operation and Configuration
Analytics On/Off—FC-Series ID only
The FC-Series ID camera Intrusion Detection Analytics can be enabled or disabled from the
Live Video page. Detection area and tripwire alarms must be setup prior to use.
Video Analytics Setup—FC-Series ID only, pg.
Refer to
De-Ice On/Off—Configuration dependent
This button manually turns the lens heater on or off. The heater, when turned on manually,
will run for approximately 2 hours unless turned off either by the user (De-Ice button) or the
thermostat control. Refer to
2.4 Basic Camera Configuration
The following procedures describe how to do the most common bench test camera configuration
steps, such as setting the camera IP address and hostname and changing the user passwords. To
make these changes, it is necessary to login using the admin account. Additional setup and
configuration options required after the camera has been installed in its final location are described
after the basic steps are given, refer to
2.4.1 Setup Menu
The Setup menu is used for GEO Settings (Latitude and Longitude location), Video setup, thermal
(IR) camera setup, and defining Video Analytics motion detection zones. For additional details, refer
Setup Menu, pg. 42.
to
Adjustments to the IR settings should only be made by someone who has expertise with thermal
cameras and a thorough understanding of how the various settings affect the image. In most
installations, the only camera settings needed are available from the Web Control panel on the Live
Video page (Scene Presets, Polarity, Palettes, and AGC). Haphazard changes can lead to image
problems including a complete loss of video. Additional information is provided in
Setup, pg. 47.
When a user logs in as admin, a complete Maintenance menu is available (refer to
Menu, pg. 54). The Maintenance menu also provides access to other configuration options.
427-0089-00-12 Version 160
Supplemental Lens Heater, pg.
Advanced Configuration, pg.
March 2019
This document does not contain any export-controlled information.
49.
7.
42.
Thermal Image
Maintenance
27