Sun Oracle Netra SPARC T5-1B Installation Manual page 50

■
■
For a list of valid boot commands, type.
{0} ok help File
boot <specifier>
Examples:
dload <filename>
at address
Examples:
Related Information
"Configure the Preinstalled OS" on page 37
■
"Reach a State to Install a Fresh OS (Oracle ILOM Web Interface)" on page 40
■
"Assign a Static IP Address to the SP" on page 44
■
▼ Assign a Static IP Address to the SP
If you plan to connect to the SP through its NET MGT port (through the dongle's
RJ-45 connector), the SP must have a valid IP address.
By default, the server module is configured to obtain an IP address from DHCP
services in your network. If the network your server module is connected to does not
support DHCP for IP addressing, perform this procedure.
To configure the server module to support DHCP, refer to the Oracle ILOM
documentation.
44 Netra SPARC T5-1B Server Module Installation Guide • October 2013
Installing Oracle Solaris 11 Systems, comparing installation options at:
http://www.oracle.com/goto/Solaris11/docs
Oracle Solaris 10 Installation Guide: Planning for Installation and Upgrade, choosing
an Oracle Solaris installation method at:
http://www.oracle.com/goto/Solaris10/docs
( -- )
boot
boot net
boot cdrom
boot disk1:h
boot tape
boot disk myunix -as
( addr -- )
4000 dload /export/root/foo/test
?go - if executable program, execute it
or if Forth program, compile it
boot kernel ( default ) or other file
- boot kernel from default device.
Factory default is to boot
from DISK if present, otherwise from NET.
- boot kernel from network
- boot kernel from CD-ROM
- boot from disk1 partition h
- boot default file from tape
- boot myunix from disk with flags "-as"
debug load of file over network