Sun Oracle Netra SPARC T5-1B Installation Manual page 40

7. Switch communication to the server module host.
When the Oracle ILOM prompt appears, type.
-> start /HOST/console
Are you sure you want to start /HOST/console (y/n)? y
Serial console started. To stop, type #.
The server module might take several minutes to complete POST. If a boot device
installed with Oracle Solaris OS is accessible locally, the server module boots.
Otherwise, the server module uses the boot net command to seek a boot device
on the network.
You are now connected to the server module host.
Note – You can perform other Oracle ILOM commands while the server
initialization continues in the background. To return to Oracle ILOM, type #. (Hash
Dot). To see information about available Oracle ILOM commands, type help. To
return to the initialization, type: start /HOST/console.
8. The server module hardware installation is now complete.
You can now configure the server module to meet your needs. See
Preinstalled OS" on page
Related Information
"Plan Communication With the Server Module During Installation" on page 15
■
"Dongle Cables" on page 17
■
▼ Power On the Host Through the CMM SER MGT
Port (CLI)
You can access the server module SP by first accessing Oracle ILOM CMM through a
terminal or terminal emulator connected to the RJ-45 serial port on the chassis. Then
you can connect to the server module SP through the Oracle ILOM CMM CLI.
1. Verify that the terminal, laptop, or terminal server that will connect to the
chassis is operational.
2. Configure the terminal device or terminal emulation software with these
settings:
■
■
34 Netra SPARC T5-1B Server Module Installation Guide • October 2013
8N1 (eight data bits, no parity, one stop bit)
9600 baud (the default, but can be set to any standard rate up to 57600)
37.
"Configure the