Sun Oracle Netra SPARC T5-1B Installation Manual page 42

6. Navigate to the server module.
-> cd /Servers/Blades/Blade_n
Replace n with a number that identifies the chassis slot in the modular system
where the target server module is installed.
7. Power on the server module host.
Replace n with a number that identifies the chassis slot in the modular system
where the target server module is installed.
-> start System
Are you sure you want to start /Servers/Blades/Blade_n/System
(y/n)? y
Starting /System. . .
The server module initializes.
8. Switch communication to the server module host.
When the Oracle ILOM prompt appears, type.
-> start HOST/console
Are you sure you want to start
/Servers/Blades/Blade_5/HOST/console (y/n)? y
Serial console started. To stop, type #.
...
The server module might take several minutes to complete POST. If a boot device
installed with Oracle Solaris OS is accessible locally, the server module boots.
Otherwise, the server module uses the boot net command to seek a boot device
on the network.
You are now connected to the server module host.
9. The server module hardware installation is now complete.
You can now configure the Oracle Solaris OS to meet your needs. See
the OS" on page
Related Information
"Plan Communication With the Server Module During Installation" on page 15
■
36 Netra SPARC T5-1B Server Module Installation Guide • October 2013
37.
"Installing