Install Optional Components - Sun Oracle Netra SPARC T5-1B Installation Manual

b. If you plan to manage the server modules through the modular system CMM,
c. Ensure that the modular system chassis is powered on and running.
d. Ensure that the modular system is running the latest version of CMM Oracle
Note – For more information about preparing the modular system and CMM Oracle
ILOM, refer to the Sun Netra 6000 Modular System Installation Guide.
2. Unpackage the server module.
Be ready to insert the server module within 60 seconds of removing the filler
panel.
3. Install any optional components.
See
Related Information
"Install Optional Components" on page 22
■
"Insert the Server Module Into the Chassis" on page 23
■

▼ Install Optional Components

Optional components that you order as part of the server module's initial
configuration are installed in the server module before it is shipped. These optional
components are identified on the customer information sheet included with the
server module's packaging.
However, if you ordered optional components separately, you must install them in
the server module before you install the server module in the modular system
chassis.
1. Install any optional components in the server module.
To install any optional components, refer to the Server Module Service Manual and
to the documentation for the optional component.
2. Close the server module.
3. Insert the server module into the chassis.
See
22 Netra SPARC T5-1B Server Module Installation Guide • October 2013
configure the CMM to run in your network.
ILOM firmware.
"Install Optional Components" on page
"Insert the Server Module Into the Chassis" on page
22.
23.