Summary of Contents for Infineon TriBoard TC3X9 Series
Page 1
About this document Scope and purpose The User Manual provide information about using, configuration and connecting the TriBoard with Infineon AURIX™ TC3X9 device. The manual provide information for different hardware types. There exist different hardware with Through Hole socket (TriBoard TC3X9 TH) and soldered devices (TriBoard TC3X9). The schematic is identically for the all boards if not other mentioned in chapter schematic.
TriBoard Manual TC3X9 Hardware: TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 Table of Contents Table of Contents About this document ............Preface-1 Table of Contents .
TriBoard Manual TC3X9 Hardware: TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 Introduction Introduction We congratulate you on your purchase of the TriCore Evaluation Board. This kit is a versatile tool, providing quick access to the capabilities of TriCore's powerful architecture. Applications can be developed easily.
Features Features Summary of Features – Infineon’s TC3X9 (TC399) AURIX™ 2G Controller in LFBGA-516 Package – Infineon’s TC3X7 (TC397) AURIX™ 2G Controller in LFBGA-292 Package – Burst Flash up to 4MBytes (not with TC3X7) – asynchronous SRAM up to 2MByte (not with TC3X7) –...
Page 6
TriBoard Manual TC3X9 Hardware: TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 Features – Infineon’s LIN-Transceiver TLE 7259-3GE – USB to UART bridge FT2232HL (FTDI) – Single Port Gigabit Ethernet PHY PEF7071 (LANTIQ) – 8 general purpose LEDs – 2K I2C Serial Eeprom with EUI-48™...
TriBoard Manual TC3X9 Hardware: TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 Features Placement Note: On soldered board the DAP connector (X402) and the crystal (Y201) are located closer to the TC3X9 (U201) as shown in Figure 2-2 other components are on the same location (see also Figure 7-12).
TriBoard Information TriBoard Information Power Supply All needed voltages are generated via Infineon’s Multi Voltage Safety Micro Processor Supply TLF35584QV and via the microcontroller itself (+1,25V). The supply device is available as two different devices: TLF35584QVVS1 -> +5V standby voltage, +5V TriCore supply (V_UC) TLF35584QVVS2 ->...
TriBoard Manual TC3X9 Hardware: TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 TriBoard Information For the On Board Memory are reserved chip select 0 and 1. Therefore only two parts, e.g. 1x32Bit Flash and 2x16Bit asynchronous SRAM, should be assembled and can be used at the same time. Chip Select 2 is used as Burst Address Advance output on the board and can be used externally only if the flash and the sysnchronous SRAM (if assembled) are not used in burst mode.
TriBoard Manual TC3X9 Hardware: TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 TriBoard Information ERAY-A can be connected to P14.8, P14.9 and P14.10 (default, usable with ERAY0 and ERAY1) and to P02.0, P02.1 and P02.4 (only usable with ERAY0). Transceiver for channel A can be enabled/disabled via P32.3 (default) or via P10.2.
TriBoard Manual TC3X9 Hardware: TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 TriBoard Information 3.11 HSCT (optional) The TriBoard provide a footprint of IEEE 1394 socket (X201) for connection to other TC3XX via HSCT. Note: Don’t use X201 for connection to any IEEE 1394 device, this can destroy the board and/or the connected device.
TriBoard Manual TC3X9 Hardware: TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 TriBoard Information 3.13 Toggle LED’s The status LED’s are low active and can be controlled by Software. Port 20 pin 11 up to pin 14 are connected to single LED’s (D306... D309) and powered by the normal microcontroller voltage.
TriBoard Manual TC3X9 Hardware: TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 TriBoard Information 3.15.4 High speed with DAP/DAPE For use the DAP connection with 160 MHz you need to remove 3 resistors to have a very short connection between device and connector.
Page 18
TriBoard Manual TC3X9 Hardware: TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 TriBoard Information remove R522. If R522 is removed then you must make sure that the EmW is always connected. Otherwise with assembled R522 (default) you should not connect the pin 4 of connector. The mentioned resistor is red marked in Figure 3-6 and :...
TriBoard Manual TC3X9 Hardware: TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 TriBoard Configuration TriBoard Configuration HW Boot Configuration Figure 4-1 HW Configuration DIP-Switches The picture above shows the definition of the boot HW configuration switch. The meaning of the switches will be described in the following table (Table 4-1).
TriBoard Manual TC3X9 Hardware: TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 Signal (on board used) Description Signal (on board used) Description For more information about the signals please see the user manual/datasheet for TC3X9 and/or the schematics of the board. All not mentioned signals are not used on the board and can be used outside.
TriBoard Manual TC3X9 Hardware: TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 Signal (on board used) Description Table 5-6 Peripheral Signals (continued) Short name Description P11.6 Ethernet TXEN Output P11.7 Ethernet RXD3 Input A P11.8 Ethernet RXD2 Input A P11.9 Ethernet RXD1 Input A P11.10 Ethernet RXD0 Input A...
Page 31
TriBoard Manual TC3X9 Hardware: TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 Signal (on board used) Description Table 5-7 EBU Signals (continued) Short name Description AD8 / P30.4 Address Data Line 8 Input/Output AD9 / P30.12 Address Data Line 9 Input/Output AD10 / P30.11 Address Data Line 10 Input/Output AD11 / P30.1...
Page 32
TriBoard Manual TC3X9 Hardware: TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 Signal (on board used) Description Table 5-7 EBU Signals (continued) Short name Description A14 / P24.2 Address Line 14 Output A15 / P24.1 Address Line 15 Output A16 / P25.15 Address Line 16 Output A17 / P25.13 Address Line 17 Output...
TriBoard Manual TC3X9 Hardware: TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 Connector Pin Assignment Connector Pin Assignment The TriBoard will be shipped with five male (plug) connectors on top layer and five female (socket) connectors on bottom layer. The default connectors are 80-pol. Board to Board connectors from Samtec: http://www.samtec.com Plug: FTSH-140-02-L-DV-ES-A...
TriBoard Manual TC3X9 Hardware: TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 Schematic and Layout Schematic and Layout Known problems 7.1.1 Known problems (TriBoard TC3X9 TH V1.0) 2 pads next to button P33.11 marked with GND are not connected to any net. 2 pads between X702 and X705 marked with GND are not connected to any net.
Page 43
TriBoard Manual TC3X9 Hardware: TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 Schematic and Layout Figure 7-1 Schematic - Project User Manual V1.2 TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 2016-08...
Page 44
TriBoard Manual TC3X9 Hardware: TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 Schematic and Layout Figure 7-2 Schematic - Clock, Config, Debug, Ports and ADC User Manual V1.2 TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 2016-08...
Page 45
TriBoard Manual TC3X9 Hardware: TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 Schematic and Layout Figure 7-3 Schematic - On Board Peripherals User Manual V1.2 TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 2016-08...
Page 46
TriBoard Manual TC3X9 Hardware: TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 Schematic and Layout Figure 7-4 Schematic - miniWiggler JDS and Debug connectors User Manual V1.2 TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 2016-08...
Page 47
TriBoard Manual TC3X9 Hardware: TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 Schematic and Layout Figure 7-5 Schematic - Power Supply User Manual V1.2 TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 2016-08...
Page 48
TriBoard Manual TC3X9 Hardware: TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 Schematic and Layout Figure 7-6 Schematic - On Board SRAM and Flash User Manual V1.2 TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 2016-08...
Page 49
TriBoard Manual TC3X9 Hardware: TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 Schematic and Layout Figure 7-7 Schematic - Connectors (Plug) User Manual V1.2 TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 2016-08...
Page 50
TriBoard Manual TC3X9 Hardware: TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 Schematic and Layout Figure 7-8 Schematic - Connectors (Socket) User Manual V1.2 TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 2016-08...
TriBoard Manual TC3X9 Hardware: TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 Schematic and Layout Layout with Dimensioning The following dimensions should be used for development of extension boards. Figure 7-13 Dimensioning (mm) User Manual 7-14 V1.2 TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 2016-08...
Page 56
TriBoard Manual TC3X9 Hardware: TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 Schematic and Layout Figure 7-14 Dimensioning (mil) The dimensioning is valid for all TriBoards. User Manual 7-15 V1.2 TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 2016-08...
Page 57
TriBoard Manual TC3X9 Hardware: TriBoard TC3X9 TH V1.0(1) and TriBoard TC3X9 V1.0 Revision History Page or Item Subjects (major changes since previous revision) V1.2, 2016-08 change to schematic version V1.02 (RC filtervalues for analogsupply changed) switch off TLF35584 failsafe state by default Remove RGMII (Gigabit Ethernet not possible with this board) User Manual RevisionHistory-1...
Page 58
Infineon Technologies, Infineon Technologies in customer's applications. Document reference Infineon Technologies’ products may not be used in The data contained in this document is exclusively Doc_Number any applications where a failure of the product or any intended for technically trained staff.