AURIX™ TC3X5 device. The manual provide information for different hardware types. There exist different hardware with Through Hole socket (TriBoard TC3X5 TH) and soldered devices (TriBoard TC3X5). The schematic is identically for the all boards if not other mentioned in chapter schematic. The placing on the boards is slightly different around the TC3X5 itself dependent of the space (socket need more space and has through hole), but the most components are on the same location.
TriBoard Manual TC3X5 Hardware: TriBoard TC3X5 TH V1.0 and TriBoard TC3X5 V1.0 Table of Contents Table of Contents About this document ..............Preface-1 Table of Contents .
TriBoard Manual TC3X5 Hardware: TriBoard TC3X5 TH V1.0 and TriBoard TC3X5 V1.0 Introduction Introduction We congratulate you on your purchase of the TriCore Evaluation Board. This kit is a versatile tool, providing quick access to the capabilities of TriCore's powerful architecture.
TriBoard Manual TC3X5 Hardware: TriBoard TC3X5 TH V1.0 and TriBoard TC3X5 V1.0 Features Features Summary of Features – Infineon’s TC3X5 (TC375) AURIX™ 2G Controller in LQFP-176 Package – FlexRay™ Transceivers – High Speed CAN Transceivers (CAN-FD capable) – USB to UART bridge –...
TriBoard Manual TC3X5 Hardware: TriBoard TC3X5 TH V1.0 and TriBoard TC3X5 V1.0 Features – Reset switch – Enable switch – Generic switch – 4-pin Dip switch Zero Ohm Bridges Zero Ohm resistors give the flexibility to configure the systems functionality.
Please check always the latest manual for complete list of usable devices. Power Supply All needed voltages are generated via Infineon’s Multi Voltage Safety Micro Processor Supply TLF35584QV and via the microcontroller itself (+1,25V). The supply device is available as two different devices: TLF35584QVVS1 ->...
TriBoard Manual TC3X5 Hardware: TriBoard TC3X5 TH V1.0 and TriBoard TC3X5 V1.0 TriBoard Information 3.5.1 Serial Connection to PC After the first connection of USB to a PC the needed driver will be installed automatically. During this there will be created a new COM port on PC. This COM port can be used to communicate with the board via ASCLIN0 of the device.
TriBoard Manual TC3X5 Hardware: TriBoard TC3X5 TH V1.0 and TriBoard TC3X5 V1.0 TriBoard Information Per default the miniWiggler is connected to the DAP. If resistors R214, R215 and R216 assembled (default) then the standard DAP is connected to miniWiggler. If all this resistors are not assembled then the miniWiggler can’t be used.
TriBoard Manual TC3X5 Hardware: TriBoard TC3X5 TH V1.0 and TriBoard TC3X5 V1.0 TriBoard Information more information about the ethernet modul see TC3X5 User’s Manual, about the PHY see the RTL8201FI datasheet. For the pinout of RJ45 see Figure 6-9. The PHY is connected to the TriCore device via resistors and resistor arrays (R368 up to R374) which must be removed to use the ports outside.
TriBoard Manual TC3X5 Hardware: TriBoard TC3X5 TH V1.0 and TriBoard TC3X5 V1.0 TriBoard Information 3.13 Other peripherals For all other peripherals there are no special plugs on the board. The peripheral signals are available on the different connectors. See “Connector Pin Assignment” on Page 6-1 3.14...
TriBoard Manual TC3X5 Hardware: TriBoard TC3X5 TH V1.0 and TriBoard TC3X5 V1.0 TriBoard Information 3.16.4 High speed with DAP For use the DAP connection with 160 MHz you need to remove 3 resistors to have a very short connection between device and connector.
Page 17
TriBoard Manual TC3X5 Hardware: TriBoard TC3X5 TH V1.0 and TriBoard TC3X5 V1.0 TriBoard Information remove R522. If R522 is removed then you must make sure that the EmW is always connected. Otherwise with assembled R522 (default) you should not connect the pin 4 of connector.
TriBoard Manual TC3X5 Hardware: TriBoard TC3X5 TH V1.0 and TriBoard TC3X5 V1.0 TriBoard Configuration TriBoard Configuration HW Boot Configuration Figure 4-1 HW Configuration DIP-Switches The picture above shows the definition of the boot HW configuration switch. The meaning of the switches will be...
TriBoard Manual TC3X5 Hardware: TriBoard TC3X5 TH V1.0 and TriBoard TC3X5 V1.0 Signal (on board used) Description Signal (on board used) Description For more information about the signals please see the user manual/datasheet for TC3X5 and/or the schematics of the board.
TriBoard Manual TC3X5 Hardware: TriBoard TC3X5 TH V1.0 and TriBoard TC3X5 V1.0 Connector Pin Assignment Connector Pin Assignment The TriBoard will be shipped with four male (plug) connectors on top layer and four female (socket) connectors on bottom layer. The default connectors are 80-pol. Board to Board connectors from Samtec: http://www.samtec.com...
TriBoard Manual TC3X5 Hardware: TriBoard TC3X5 TH V1.0 and TriBoard TC3X5 V1.0 Schematic and Layout Schematic and Layout Known problems 7.1.1 Known problems on TriBoard TC3X5 TH V1.0 Pinnumber of ESR0 and ESR1 on TC3X5 is swapped in this schematic.
Page 36
TriBoard Manual TC3X5 Hardware: TriBoard TC3X5 TH V1.0 and TriBoard TC3X5 V1.0 Schematic and Layout Figure 7-1 Schematic - Project User Manual V1.0 TriBoard TC3X5 TH V1.0 and TriBoard TC3X5 V1.0 2018-12...
Page 37
TriBoard Manual TC3X5 Hardware: TriBoard TC3X5 TH V1.0 and TriBoard TC3X5 V1.0 Schematic and Layout Figure 7-2 Schematic - Clock, Config, Debug, Ports and ADC User Manual V1.0 TriBoard TC3X5 TH V1.0 and TriBoard TC3X5 V1.0 2018-12...
Page 38
TriBoard Manual TC3X5 Hardware: TriBoard TC3X5 TH V1.0 and TriBoard TC3X5 V1.0 Schematic and Layout Figure 7-3 Schematic - On Board Peripherals User Manual V1.0 TriBoard TC3X5 TH V1.0 and TriBoard TC3X5 V1.0 2018-12...
Page 39
TriBoard Manual TC3X5 Hardware: TriBoard TC3X5 TH V1.0 and TriBoard TC3X5 V1.0 Schematic and Layout Figure 7-4 Schematic - miniWiggler JDS and Debug connectors User Manual V1.0 TriBoard TC3X5 TH V1.0 and TriBoard TC3X5 V1.0 2018-12...
Page 40
TriBoard Manual TC3X5 Hardware: TriBoard TC3X5 TH V1.0 and TriBoard TC3X5 V1.0 Schematic and Layout Figure 7-5 Schematic - Power Supply User Manual V1.0 TriBoard TC3X5 TH V1.0 and TriBoard TC3X5 V1.0 2018-12...
Page 41
TriBoard Manual TC3X5 Hardware: TriBoard TC3X5 TH V1.0 and TriBoard TC3X5 V1.0 Schematic and Layout Figure 7-6 Schematic - Connectors (Plug) User Manual V1.0 TriBoard TC3X5 TH V1.0 and TriBoard TC3X5 V1.0 2018-12...
Page 42
TriBoard Manual TC3X5 Hardware: TriBoard TC3X5 TH V1.0 and TriBoard TC3X5 V1.0 Schematic and Layout Figure 7-7 Schematic - Connectors (Socket) User Manual V1.0 TriBoard TC3X5 TH V1.0 and TriBoard TC3X5 V1.0 2018-12...
TriBoard Manual TC3X5 Hardware: TriBoard TC3X5 TH V1.0 and TriBoard TC3X5 V1.0 Schematic and Layout Layout with Dimensioning The following dimensions should be used for development of extension boards. Figure 7-10 Dimensioning (mm) User Manual 7-11 V1.0 TriBoard TC3X5 TH V1.0 and TriBoard TC3X5 V1.0...
Page 46
TriBoard Manual TC3X5 Hardware: TriBoard TC3X5 TH V1.0 and TriBoard TC3X5 V1.0 Schematic and Layout Figure 7-11 Dimensioning (mil) The dimensioning is valid for all TriBoards. User Manual 7-12 V1.0 TriBoard TC3X5 TH V1.0 and TriBoard TC3X5 V1.0 2018-12...
Page 47
TriBoard Manual TC3X5 Hardware: TriBoard TC3X5 TH V1.0 and TriBoard TC3X5 V1.0 Revision History Page or Item Subjects (major changes since previous revision) V1.0, 2018-12 User Manual RevisionHistory-1 V1.0 TriBoard TC3X5 TH V1.0 and TriBoard TC3X5 V1.0 2018-12...
Page 48
Infineon Technologies, Infineon Technologies in customer's applications. Document reference Infineon Technologies’ products may not be used in The data contained in this document is exclusively Doc_Number any applications where a failure of the product or any intended for technically trained staff.
Need help?
Do you have a question about the TriBoard TC3X5 and is the answer not in the manual?
Questions and answers