fantastic furniture HAVANA Table Nest Rectangle Assembly Instructions Manual page 5

Step 1
You will need
6 x Small
6 x Cam Bolts
Dowels (H8)
(H2)
1 x Glue Phillips head
(H10) screwdriver
H10
H10
Squeeze Glue (H10) into dowel holes in Legs (P2, P3, P4, P5) and insert 6 x Small Dowels (H8).
Screw 6 x Cam Bolts (H2) into place using a Phillips head screwdriver.
Step 2
You will need
1 x Glue
4 x Cam Nuts
(H10)
(H3)
Flat head
screwdriver
This is how a cam nut works ........
The head of the cam
bolt goes into the open
mouth of the cam nut.
You then turn the cam
nut so it tightens over
the bolt.
Squeeze Glue (H10) into the dowel holes in Short Aprons (P7).
Insert 4 x Cam Nuts (H4) into the holes of Short Aprons (P7) as shown.
Rotate the cam nuts so the arrows point towards the incoming cam bolts.
Attach Legs (P2, P4) and Legs (P3, P5) to Short Aprons (P7),
then tighten the cam nuts using a Flat head screwdriver.
www.fantasticfurniture.com.au
H8
(P2)
H8
H8
H2
(P5)
Make sure the side with the bigger
holes of the Short Aprons (P7)
is facing to the bottom of Legs.
H10
H2
H8
H2
H8
H3
H3
(P7)
(P2)
H3
H3
(P7)
(P5)
H8
H2
H2
(P4)
H2
(P3)
(P4)
(P3)
PAGE 5