3
Installing the Rod Cam Sensor
Parts needed for this procedure:
1
Bracket
2
Bolt (M12-1 3/4 x 60 mm)
2
Locknut (M12)
1
Hex nut (M10)
2
Bolt (M4)
1
Sensor assembly
2
Nut (M4)
2
Cotter pins
1
Sensor harness adapter
1
Sensor-connector clip
Procedure
Refer to location highlighted in
Figure 10
1. Remove the cotter pins on the elevator cylinder
11).
Note: Do not disconnect the hydraulic hoses.
Figure 10
for this procedure.
(Figure
2. Place the elevator cylinder aside to gain access to the
sensor bracket.
3. Remove the sensor assembly and bracket as shown in
Box A of
Figure
1. Locknuts (M12)
2. Bolts (M12-1 3/4 x 60 mm) 5. Flat washers
3. Bracket
4. Loosely install the new bracket with 2 bolts (M12-1
3/4 x 60mm) and 2 locknuts (M12) as shown in Box
B of
Figure
12.
5
Figure 11
12.
Figure 12
4. Hex nut (M10)
6. Bolt (M10)