Toro 4045 Installation Instructions Manual page 2

Procedure
3
4
5
1
Installing the Rod Loader
Spacer
Parts needed for this procedure:
1 Thrust washer
1 Washer
1 Flange locknut
Procedure
Refer to location highlighted in
1. Support the rod loader assembly to ensure that the
pivot pin assembly is able to move.
2. Remove the sensor assembly and bracket and set aside
the hardware (Figure
Description
Bracket
Bolt (M12-1 3/4 x 60 mm)
Locknut (M12)
Hex nut (M10)
Bolt (M4)
Sensor assembly
Nut (M4)
Cotter pins
Sensor harness adapter
Sensor-connector clip
Gasket
Monitor cap
Decal
Figure 1 for this procedure.
Figure 1
2).
Qty.
1
2
2
1
2
Install the rod cam sensor.
1
2
2
1
1
Removing the rotary pump supply and
1
drain orifices.
1
Install the cap and decal.
1
3. Remove the retaining bolt and nut as shown in
1. Retaining nut (existing)
4. Move the rod-loader assembly to the side to create a
gap for the washer.
2
Use
Figure 2
Figure 3
2. Retaining bolt (existing)
Figure 3.