Advertisement
CP2000-S/-SB/-H/-I/-X/-XB/-M/-MR AND ROADIE 25K/D+30K/HD+35K
FILLING THE RESERVOIR
1. Loosen the top screw (Figure 6) and use the fill bottle to add coolant. Power up the projector and
continue adding coolant so the fluid level does not drop below the Minimum Fill Line.
2. Air Bubble Impeding Flow: If the liquid in the reservoir does not move due to air bubbles,
remove the entire fan pack and pump section. For instructions, refer to the CP2000-M/MR
Service Manual (P/N: 020-100124-xx). Tilt the pump at different angles until the coolant starts to
flow.
4 of 9
Figure 6 Fill the Reservoir
(Reservoir for CP2210, CP2220 and CP2230 shown)
Coolant Refill Instruction Sheet
020-100686-01 Rev. 1 (03-2011)
Advertisement
