Leica SL2 Instruction Manual page 205

Images are overexposed
Out of focus/picture stabilizer not functioning
The image is grainy or there is image noise
Horizontal stripes
Unnatural colors and brightness
No images are displayed
Images cannot be displayed
Video quality
Video recordings show flickering/stripes
Camera noise in video recording
No sound on video recording
Flickering or horizontal stripes in the video
recording
Flash is activated in bright surroundings
Strong light source in the image
(Half) backlight falling into the lens (also from light
sources outside the image range)
Exposure at a dark location without flash
ISO sensitivity set too high
Picture was taken with electronic shutter under a light
source like a fluorescent lamp
Picture taken in artificial light or extreme brightness
Memory card is empty or not inserted
File name of the image was changed on a PC
Light source interference in artificial lighting
The setting dials were used
Playback volume is set too low
Microphone was covered during recording
Speakers are covered
Microphone was deactivated while recording
CMOS sensors will display this phenomenon when light
sources like LED lamps or fluorescent tubes are used
Change the flash mode
Avoid strong light sources in picture composition
Use the lens hood or change to another subject
Use a tripod
Decrease ISO sensitivity
Try shorter shutter speeds
Set white balance or select correct lighting presets
Use appropriate software for image transfers from a PC
to the camera; available from the Leica AG website
Select a different frame rate (suitable for the local AC
grid frequency) under
Video Resolution Video Resolution
Avoid using the setting dials during video recordings
Increase playback volume
Make sure the microphone is not obstructed while
recording video
Make sure that speakers are unobstructed during
playback
Activate the microphone
Quality may be improved by selecting a manual shutter
speed (e.g. 1/100 s)
EN
205