Connecting The D-Rgb Led Strip; Connecting The Pump - ekwb EK-Quantum Reflection PC-O11D D5 PWM D-RGB User Manual

CONNECTING THE D-RGB LED STRIP

CONNECTING THE PUMP

4-pin molex
connector
4-pin PWM fan
connector
D-RGB Header
RGB Header
The EK-D5 PWM pump has two connectors.
1. 4-pin Molex: It must be connected directly to your PSU at all
2. 4-pin PWM fan: It can be connected to your motherboard's
- 9 -
Plug the 3-pin connector of the distribution plate D-RGB LED light
to the D-RGB HEADER on the motherboard. The LED will work if the
pin layout on the header is as follows: +5V, Digital, Empty, Ground.
times as it is used to power the pump.
CPU_ Fan or designated water pump header. It can also be
connected to a controller. This cable is used to control and report
the rotational speed of the pump. If it's not connected, the pump
will run at maximum speed (100% PWM).